Laser Cutter
From Knox Makers Wiki
(Difference between revisions)
Andronicus (Talk | contribs) (Created page with "http://www.buildlog.net/wiki/doku.php?id=2x:2.x_laser") |
Andronicus (Talk | contribs) |
||
| Line 1: | Line 1: | ||
http://www.buildlog.net/wiki/doku.php?id=2x:2.x_laser | http://www.buildlog.net/wiki/doku.php?id=2x:2.x_laser | ||
| + | |||
| + | '''To Do List''' | ||
| + | |||
| + | Buy/build shaft couplers for y-axis | ||
| + | |||
| + | Buy honeycomb surface | ||
| + | |||
| + | Buy large z-axis gear | ||
| + | |||
| + | Buy Pololu motor drivers | ||
| + | |||
| + | Specify limit switches | ||
| + | |||
| + | Buy limit switches | ||
| + | |||
| + | Cut 1/4" aluminum rod stock to 12" & 14" sections for | ||
| + | |||
| + | Machine air assist nozzle | ||
| + | |||
| + | Build roll around table | ||
| + | |||
| + | Determine electronics setup | ||
Revision as of 00:33, 20 October 2012
http://www.buildlog.net/wiki/doku.php?id=2x:2.x_laser
To Do List
Buy/build shaft couplers for y-axis
Buy honeycomb surface
Buy large z-axis gear
Buy Pololu motor drivers
Specify limit switches
Buy limit switches
Cut 1/4" aluminum rod stock to 12" & 14" sections for
Machine air assist nozzle
Build roll around table
Determine electronics setup
