Laser Cutter
From Knox Makers Wiki
(Difference between revisions)
Andronicus (Talk | contribs) |
(→To Do List) |
||
| Line 26: | Line 26: | ||
* Buy cable carriers | * Buy cable carriers | ||
* <strike>Buy Pololu motor drivers</strike> --[[User:Andronicus|Andronicus]] 00:50, 20 October 2012 (EDT) | * <strike>Buy Pololu motor drivers</strike> --[[User:Andronicus|Andronicus]] 00:50, 20 October 2012 (EDT) | ||
| − | * Buy Pololu heat sinks | + | * <strike>Buy</strike> Get Pololu heat sinks from Brian |
* Specify limit switches | * Specify limit switches | ||
* Buy limit switches | * Buy limit switches | ||
Revision as of 03:46, 23 October 2012
Contents |
Theory / General Info
Laser
- Good notes on controlling the intensity of the laser with PWM - Laser Power Settings Via PWM Can Fool You
Optics
Linear Motion
Electronics
- Potential arduino shield to use with LasaurGrbl - LasaurShield
Software
- Potential controller software based on Grbl- LasaurGrbl
- Software to run on Mac/PC to send G-code to LasaurGrbl - LasaurApp
Build Notes
- The laser cutter being built is based around the laser cutter on Buildlog.net
- Another good reference is Lasersaur
To Do List
- Buy/build shaft couplers for y-axis
- Buy honeycomb surface
-
Buy large z-axis gear and timing belt--Andronicus 18:31, 20 October 2012 (EDT) - Buy cable carriers
-
Buy Pololu motor drivers--Andronicus 00:50, 20 October 2012 (EDT) -
BuyGet Pololu heat sinks from Brian - Specify limit switches
- Buy limit switches
-
Cut 1/4" aluminum rod stock to 12" & 14" sections for y-axis shafts--Andronicus 18:31, 20 October 2012 (EDT) - Machine air assist nozzle
- Build roll around table
- Determine electronics setup
