Makerbot Cupcake
From Knox Makers Wiki
(Difference between revisions)
Andronicus (Talk | contribs) (Created page with "<pre> // If you are using a preconfigured hotend then you can use one of the value sets by uncommenting it +// Makerbot Cupcake with Mk 6 Plus Extruder + #define DEFAULT_Kp 6...") |
Andronicus (Talk | contribs) |
||
| Line 6: | Line 6: | ||
+ #define DEFAULT_Kd 440.0 | + #define DEFAULT_Kd 440.0 | ||
</pre> | </pre> | ||
| + | |||
| + | <pre> | ||
| + | // default settings | ||
| + | |||
| + | #define DEFAULT_AXIS_STEPS_PER_UNIT {78.7402,78.7402,2560,760*1.1} // default steps per unit for ultimaker 760*1.1 | ||
| + | #define DEFAULT_MAX_FEEDRATE {5000/60, 5000/60, 150/60, 5000/60} // (mm/sec) | ||
| + | #define DEFAULT_MAX_ACCELERATION {900,900,10,10000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for skeinforge 40+, for older versions raise them a lot. | ||
| + | |||
| + | #define DEFAULT_ACCELERATION 900 // X, Y, Z and E max acceleration in mm/s^2 for printing moves | ||
| + | #define DEFAULT_RETRACT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for r retracts | ||
| + | </pre> | ||
| + | NOT SURE IF THESE ARE CORRECT | ||
Latest revision as of 17:19, 4 November 2012
// If you are using a preconfigured hotend then you can use one of the value sets by uncommenting it +// Makerbot Cupcake with Mk 6 Plus Extruder + #define DEFAULT_Kp 63.0 + #define DEFAULT_Ki 2.25 + #define DEFAULT_Kd 440.0
// default settings
#define DEFAULT_AXIS_STEPS_PER_UNIT {78.7402,78.7402,2560,760*1.1} // default steps per unit for ultimaker 760*1.1
#define DEFAULT_MAX_FEEDRATE {5000/60, 5000/60, 150/60, 5000/60} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {900,900,10,10000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for skeinforge 40+, for older versions raise them a lot.
#define DEFAULT_ACCELERATION 900 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for r retracts
NOT SURE IF THESE ARE CORRECT
